在感应玻璃门日常使用的过程中，常见的故障就是突然打不开了或者突然关不上了？遇到这种故障你知道如何办吗？今天门道佰分佰小编就根据平常维修感应玻璃门故障的经验为大家总结了一些维修方法。希望对广大感应玻璃门使用客户有所帮助。

In the process of daily use of the induction glass door, the common fault is that it can not be opened or closed suddenly? Do you know what to do in case of such failure? Today, doorway baifenbai Xiaobian summarized some maintenance methods for you based on the experience of ordinary maintenance of induction glass doors. It is hoped that it will be helpful to customers who use induction glass doors.

检查是否是感应玻璃门防夹功能在作怪，导致感应玻璃门打不开。

Check whether the anti pinch function of the sensing glass door is causing trouble, resulting in the non opening of the sensing glass door.

感应玻璃门机具有防夹功能，遇到障碍或感应玻璃门碰撞会导致感应玻璃门不能正常打开，在达到三次时，感应玻璃门将会停止运行，门扇会停止开门或关闭，遇到这种问题只需将门扇推完全打开状态即可恢复。

The induction glass door machine has the anti pinch function. The induction glass door cannot be opened normally in case of obstacles or collision of the induction glass door. When it reaches three times, the induction glass door will stop running, and the door leaf will stop opening or closing. In case of such problems, just push the door leaf to the fully open state to recover.

感应玻璃门内部皮带装反，导致感应玻璃门关不上。

The inner belt of the induction glass door is installed reversely, resulting in that the induction glass door cannot be closed.

济南卷帘门厂家提醒，在人通行时，感应玻璃门关闭反而走开时感应玻璃门打开并且打开后不再关闭。遇到这种情况大家都会认为这是关不上打不开了。这个问题是因为感应玻璃门在安装或维修时因为技术人员不，把动力皮带装反了导致。解决方法是一、调换皮带上下扣连接，三、控制器故障导致感应玻璃门出现打不开和关不上。

Jinan roller shutter door manufacturer reminds that when people pass through, the sensing glass door is closed, but when they walk away, the sensing glass door is opened and will not be closed after it is opened. In this case, everyone will think that it cannot be closed or opened. This problem is caused by the reverse installation of the power belt during the installation or maintenance of the induction glass door due to the unprofessional technicians. The solutions are: 1. Replace the upper and lower buckle connection of the belt; 3. The sensor glass door cannot be opened or closed due to the controller failure.

遇到这种故障需要调试控制器，如调试不能使其恢复正常，就需要更换控制器了。所以建议大家在进行维护安装时应找人员，不可因小失大。

In case of such fault, the controller needs to be debugged. If the debugging fails to restore it to normal, the controller needs to be replaced. Therefore, it is suggested that you should find professional personnel when carrying out maintenance and installation, and do not lose money for small gain.

感应玻璃门敞开或关闭的情况下接通电源无反应

When the sensing glass door is open or closed, there is no response when the power is turned on

这情况需要到现场进行检测，因为出现这个问题的情况比较多，比如虽然插上电源但没有供电也有可能是控制器死机等原因造成。门道佰分佰技术人员可现场对此问题进行检测并针对性解决问题。

This situation needs to be detected on site, because there are many cases of this problem. For example, although the power supply is plugged in but there is no power supply, it may also be caused by the controller crash and other reasons. Doorway technicians can detect and solve this problem on site.

遥控器问题，导致感应玻璃门打不开。

There is a problem with the remote control, causing the sensing glass door to not open.

因感应玻璃门遥控器问题导致，用要看解锁即可。

It is caused by a problem with the remote control of the induction glass door. You can unlock it if you want.

感应玻璃门有关门动作，但无法关闭。

The sensing glass door has closing action, but cannot be closed.

济南卷帘门厂家认为此种原因是感应器有开门信号输入，也就是感应器感应范围内有干扰物存在，比如：太阳光直射、有活动的物体、有不稳定光源等。可以通过断掉感应器信号线来测试是否因为感应器的干扰信号引起感应玻璃门无法关闭。

Jinan roller shutter door manufacturer believes that the reason is that the sensor has a door opening signal input, that is, there are interfering objects within the sensor sensing range, such as direct sunlight, moving objects, unstable light sources, etc. The sensor signal line can be cut off to test whether the inductive glass door cannot be closed due to the interference signal of the sensor.

感应玻璃门始终保持开启状态。

The sensing glass door is always open.

引发此感应玻璃门故障的原因可能是感应器损坏，始终有开门信号输入给感应玻璃门控制器，可能是感应玻璃门遥控器或模式切换开关调整到了敞开状态，如果是安装有门禁系统，可能是门禁系统继电器损坏。

The reason for this induction glass door fault may be that the sensor is damaged. There is always a door opening signal input to the induction glass door controller. It may be that the remote control or mode switch of the induction glass door is adjusted to the open state. If the access control system is installed, it may be that the access control system relay is damaged.

感应玻璃门打不开关不上可能还会有其他问题导致，这些问题需现场检测维修。以上就是今天为大家分享的关于问题的相关内容，希望对大家能有所帮助，想要了解更多内容可以电话联系我们或者关注我们的网站http://www.jnzxmy.com。

There may be other problems caused by the non opening and closing of the induction glass door. These problems need to be inspected and repaired on site. The above is the relevant content about the problem shared for you today. I hope it can help you. If you want to know more, you can contact us by phone or follow our website http://www.jnzxmy.com 。