电动卷帘门的限位调整是确保其正常运行的重要步骤。以下是调整电动卷帘门限位的详细步骤：

　　The limit adjustment of electric rolling shutter doors is an important step to ensure their normal operation. The following are the detailed steps for adjusting the threshold of the electric roller shutter:

　　一、准备工具和材料

　　1、 Prepare tools and materials

　　螺丝刀（包括菲利普螺丝刀、平面螺丝刀等）

　　Screwdrivers (including Phillips screwdrivers, flat screwdrivers, etc.)

　　扳手

　　Wrench

　　电工胶带（可选，用于电线连接处的绝缘处理）

　　Electrical tape (optional, used for insulation treatment at wire connections)

　　绝缘手套（确保，防止触电）

　　Insulated gloves (to ensure safety and prevent electric shock)

　　二、调整上限位

　　2、 Adjust the upper limit

　　断电准备：

　　Power outage preparation:

　　在进行任何调节前，确保电动卷帘门已断电，以避免在操作过程中发生电击或意外闭合。

　　Before making any adjustments, ensure that the electric rolling shutter door is powered off to avoid electric shock or accidental closure during operation.

　　定位上限位开关：

　　Positioning upper limit switch:

　　通常位于电机旁边，与电机相连，用于控制卷帘门上升到点。

　　Usually located next to the motor and connected to it, it is used to control the rolling shutter door to rise to the highest point.

　　手动调节门帘位置：

　　Manually adjust the position of the door curtain:

　　手动将卷帘门拉希望它完全打开的位置。

　　Manually pull the rolling shutter door to the desired fully open position.

　　调整上限位开关：

　　Adjust the upper limit switch:

　　使用螺丝刀调整上限位的调节螺钉。顺时针调节通常会提高上限位，逆时针调节会降低上限位。

　　Use a screwdriver to adjust the upper limit adjustment screw. Clockwise adjustment usually increases the upper limit, while counterclockwise adjustment decreases the upper limit.

　　调整过程中，可轻轻按压上限位开关，观察卷帘门是否能够顺利停止上升，并保持在设定的高度。

　　During the adjustment process, gently press the upper limit switch to observe whether the rolling shutter door can stop rising smoothly and maintain the set height.

　　测试与调整：

　　Testing and adjustment:

　　完成调节后，重新通电，测试卷帘门的开启状态，观察门帘是否可以顺畅升起并停在设定位置。

　　After completing the adjustment, power on again, test the opening status of the rolling shutter door, and observe whether the door curtain can rise smoothly and stop at the set position.

　　如有需要，可再次调整上限位开关的位置，直到达到预期效果。

　　If necessary, adjust the position of the upper limit switch again until the desired effect is achieved.

　　三、调整下限位

　　3、 Adjust the lower limit

　　断电准备（同上限位调整步骤1）。

　　Power off preparation (same as upper limit adjustment step 1).

　　定位下限位开关：

　　Position the lower limit switch:

　　通常位于电机旁边或轨道的另一端，用于控制卷帘门下降到点。

　　Usually located next to the motor or at the other end of the track, it is used to control the rolling shutter door to descend to the lowest point.

　　手动调节门帘位置：

　　Manually adjust the position of the door curtain:

　　手动将卷帘门降希望它完全关闭的位置。

　　Manually lower the rolling shutter door to the desired fully closed position.

　　调整下限位开关：

　　Adjust the lower limit switch:

　　使用螺丝刀调整下限位的调节螺钉。顺时针旋转通常会增加下限位，而逆时针旋转则会降低下限位。

　　Use a screwdriver to adjust the lower limit adjustment screw. Clockwise rotation usually increases the lower limit, while counterclockwise rotation decreases the lower limit.

　　调整过程中，可轻轻按压下限位开关，观察卷帘门是否能够顺利停止下降，并保持在设定的高度。

　　During the adjustment process, gently press the lower limit switch to observe whether the rolling shutter door can smoothly stop descending and maintain the set height.

　　测试与调整（同上限位调整步骤5）。

　　Testing and adjustment (same as upper limit adjustment step 5).

　　四、注意事项

　　4、 Precautions

　　：在调整过程中，务必确保电源已完全切断，并佩戴绝缘手套以防触电。

　　Safety first: During the adjustment process, make sure that the power supply is completely cut off and wear insulated gloves to prevent electric shock.

　　细致观察：在调整限位开关时，要细致观察卷帘门的运动状态，确保其在设定位置能够准确停止。

　　Careful observation: When adjusting the limit switch, carefully observe the movement status of the rolling shutter door to ensure that it can accurately stop at the set position.

　　反复测试：每次调整后都要进行反复测试，确保卷帘门的运行平稳且符合预期。

　　Repeated testing: After each adjustment, it is necessary to conduct repeated testing to ensure that the operation of the rolling shutter door is smooth and meets expectations.

　　维护记录：建议记录每次调整的日期、调整前后的限位位置以及测试结果等信息，以便日后维护和排查故障。

　　Maintenance records: It is recommended to record the date of each adjustment, the limit position before and after the adjustment, and the test results for future maintenance and troubleshooting.

　　通过以上步骤，您可以成功调整电动卷帘门的限位开关，确保其正常运行并满足使用需求。

　　By following the above steps, you can successfully adjust the limit switch of the electric rolling shutter door to ensure its normal operation and meet the usage requirements.

　　本文由 济南卷帘门 友情奉献.更多有关的知识请点击  http://www.jnzxmy.com   真诚的态度.为您提供为的服务.更多有关的知识我们将会陆续向大家奉献.敬请期待.

　　This article is a friendly contribution from Jinan Rolling Shutter Doors For more related knowledge, please click http://www.jnzxmy.com Sincere attitude To provide you with comprehensive services We will gradually contribute more relevant knowledge to everyone Coming soon.